EasyEcu 3+

EasyEcu 3+The EasyEcu 3+ controller is designed to control engines with a maximum number of cylinders 8. As the software develops, support for various triggers and ignition systems will be added. Initially, triggers in the form of gears, e. g. 60 2, 36 1, as well as wasted spark and ignition distributor systems will be supported. In addition, EasyEcu 3+ has a built in Bosch LSU4. 9 broadband oxygen sensor controller and a 3 bar MAP sensor. The hardware (input

The EasyEcu 3+ controller is designed to control engines with a maximum number of cylinders 8. As the software develops, support for various triggers and ignition systems will be added. Initially, triggers in the form of gears, e.g. 60-2, 36-1, as well as wasted spark and ignition distributor systems will be supported. In addition, EasyEcu 3+ has a built-in Bosch LSU4.9 broadband oxygen sensor controller and a 3 bar MAP sensor.

The hardware (input / output) capabilities of the EasyEcu 3+ controller are as follows:

• 2 high-ohm injector outputs (in one or two banks)
• 4 ignition outputs (passive coils) Note 1
• 6 logic level 5V ignition outputs (active coils)
• 1 low speed valve (electromagnetic type)
• 1 idle valve (stepper motor) Note 2
• 1 fuel pump relay
• 1 additional output in the open collector system with a capacity of 3A
• 1 12V tachometer output
• 1 shaft position input (VR or HALL)
• 1 shaft position input or shaft reference (VR or HALL)
• 1 shaft position input dedicated for ignition systems with ignition distributor (HALL)
• 1 vehicle speed sensor input
• 1 engine temperature sensor input
• 1 input of the intake air temperature sensor
• 1 throttle position sensor input
• 1 narrowband lambda probe input
• 1 exhaust gas temperature measurement input
• 2 function inputs (e.g. start procedure switch)
• 2 analogue inputs 0-5V
• 1 additional temperature measurement input
• 2 knock sensor inputs

Note 1 and 2 It is possible to extend the ignition outputs for passive coils with an additional 4 channels. Additional ignition outputs are located on the control outputs of the idle valve in the form of a stepper motor. In this option, only the control of the low-speed solenoid valve is available. In return, we get 8 ignition channels supporting passive coils. Select the appropriate option when placing the order (Hardware options).