Attwood Ski Mirror Wide-View

Attwood Ski Mirror Wide-ViewAttwood Ski Mirror Wide ViewThe Attwood Ski Mirror Wide View provides extra wide mirror for safe visibility. Features a molded plastic frame, polished convex mirror, and adjustable base. The base adjusts to any position up and down or side to side, then secures in desired location. Allen wrench included. For installation on windshields 1 2" to 1" thick (or thinner with customer's own spacer).**In some states and provinces, ski mirror of a certain size

Attwood Ski Mirror Wide-ViewThe Attwood Ski Mirror Wide-View provides extra-wide mirror for safe visibility. Features a molded plastic frame, polished convex mirror, and adjustable base. The base adjusts to any position up-and-down or side-to-side, then secures in desired location. Allen wrench included.For installation on windshields 1/2" to 1" thick (or thinner with customer's own spacer).**In some states and provinces, ski mirror of a certain size/dimension, and/or an onboard observer may be required. Check local requirements.**Installation InstructionsHOW TO INSTALL ATTWOOD SKI MIRROR – WIDE-VIEWNeeded for Installation:Phillips head screwdriverSmall flat-head screwdriver(2) #10 stainless panhead screws (for surface mounting)Drill and suitable drill bit (for surface mounting)**When deciding on a location for your mirror, ensure that it does not block forward vision**Bracket Mounting InstructionsWindshield MountPlace the bracket over the windshield frame and clamp by tightening the two setscrews that are installed in the base. DO NOT OVER TIGHTENOn windshield frames less than 5/8” thick, place a rigid spacer between the setscrews and the frame.Flat Surface MountSelect a suitable location making sure that the holes can be drilled without damaging hidden wires, ect.Place bracket in desired location and mark hole locations.After drilling holes, install bracket with #10 screws and tighten securely.After surface mounting, remove the two setscrews from the base.Mirror Mounting InstructionsInsert the tab on the back of the mirror into the slot in the bracket. Orient the mirror to the desired position, making sure that both setscrews are making contact with the tab.Tighten the setscrews enough to hold the mirror in place. Ensure the mirror is correctly placed and has sufficient adjustment to accommodate users of different heights.Fully tighten setscrews. DO NOT OVER TIGHTENAdjust the mirror to the desired position. Lightly tighten bolts on the back of the mirror.Note: If mirror moves during use, tighten bolts further.Information sourced from the Attwood Ski Mirror Installation InstructionsCalifornia Residents:WARNINGCancer and Reproductive Harm -P65Warnings.ca.gov